![]() My main intrest is Fire, much more so than Police, so I guess thats why I haven'y made time to work it out yet. Yes, thats pretty much what i was trying to suggest, I don't have any of my radios programmed that way (yet), it is something I have been thinking of doing though. ARC-XT PRO V1.The more I think about it, the more I like it.You can read TWhitson's review of this software here.Two tone decoder using Python on any platform- Decoding Fire Tone Outs in Python.Midian Electronics has a signaling chart of the various industry standard tone signaling formats.What tone frequencies are used and why are some tones longer than others? On VHF-Lo (25-50 MHz.) use "FM" mode, on VHF-Hi (140-174 MHz.) and UHF above 400 MHz.) use NFM for most situations. Try changing the modulation from Auto to one of the other 2 modes, dependent on what the correct default is for the frequency being monitored. Per UPman, setting the wrong mode will affect the accuracy of the decoding.I'm missing calls decoding doesn't seem to be reliable. The scanner will then display decoded tones accurate enough to program into the radio for use. You can also set your scanner's "A" and "B" tones both to "0" (zero) and that sets it to Tone Search mode. Fire personnel are often reluctant to give out this information.The Fire Tone Outs for my area aren't in the wiki. Where can I find the tone outs for my area? Later firmware releases deleted the need to know this information. I don't know the tone timing for my local paging system for FTO use The unit will alert on any tone on the same frequency (and mode). A tone alert on ANY will alert you whether that is the one currently displayed or not. The scanner is showing you all systems it is actively looking for.Use as a scanner, or monitoring for a FTO, but not both. No, only one function can be active at a time.See the Connecting Radios to Soundcards article for more on this subjectĬan I use the scanner and FTO at the same time? A good clean connection from the PC to the soundcard is often all that is needed. No discriminator tap is required, as the tones are generally within a voice range of audio frequencies.What do I need to connect a scanner that isn't FTO capable to measure it? Is a discriminator tap needed? This includes Uniden scanners that don't have FTO capability, RS or GRE scanners, AOR, ect. However, any scanner can be utilized to measure the FTO, using the right software (some suggested links are below). Currently only the Uniden DMA scanners are actually set up to react to a FTO. ![]() Easier to Read SDS100/200 Manual - Tone Out For MenuĬan a non-Uniden DMA scanner be set up to measure or react to a FTO?. ![]() Easier to Read BCD436HP/BCD536HP Manual - Tone Out For Menu. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |